Find Information About Lots of Great Topics

Commercial carpet cleaning equipment can vary in how they remove dirt or grime from your carpets, but they usually utilize some of the same techniques: Foam, shampoo, bonnet, dry and steam. Each method has its own advantages and disadvantages and if you’re looking to buy your own equipment it would be smart to find out what those are to make sure that you purchase the right equipment.

The commercial carpet cleaning equipment that utilizes foam is a bit special in that it applies shampoo to its brushes and works that shampoo into the carpet. Much like conditioner, you have to wait an hour or two until it driesand then take the time to vacuum the area. The advantage is that it works for high traffic areas. The general disadvantage with this method is that the shampoo could indeed just stay within the carpet, forcing you to use another carpet cleaning method just to clean up its mess.

Carpet cleaners that use the old straight shampooing method are a little less reliable than the other cleaning methods. It essentially scrubs the carpet with a buffer and shampoo the same way you’d buff a floor. As it applies a lot of pressure to the carpeting, this can easily damage your floor and carpet. Also, this method essentially only spreads the dirt around the floor and does not clean it up. You will after to vacuum up later to finish the job.

Bonnet cleaning might be your best choice when looking for commercial carpet cleaning equipment. After attaching a bonnet to a buffer, dip it into a solution of shampoo as always. The bonnet attachment is what picks up the dirt, and when it gets too dirty all you need to do is wash and attach it again. A vacuuming follows and after thirty minutes of drying, you’ve got a clean carpet.

Dry methods tend to raise eyebrows from many cleaners, though some view it as the best thing to hit carpet cleaning. The three part procedure starts with the sprinkling of a powdered solvent onto the carpet. Leave it there for fifteen minutes. A buffer with two rotating heads is then applied to the carpet, pushing the cleaning powder further into the carpet fibers. The third step is simply vacuuming it all up and then you are done. This is preferred by some because there is no drying to be done.

If you want the deepest clean, then the method you’re going to want to use is steam cleaning. It takes up to eight hours though, so it is used when you have the time and you really need a clean carpet. Very hot steam and a buffer works through your floor in steam cleaning, and it does take too go-overs, but it definitely takes the most dirt out of any carpet.

The best commercial carpet cleaning equipment for you is always the one that fits your needs and budget. Figure out what you really need and how much you can spend, and then you know what kind to invest in.

Deciding on equipment to clean your carpet can be a confusing due to the large amount of machine choices available. Choosing the right type of commercial carpet cleaning equipment can be even more difficult.

Popularity: unranked [?]